ECEN 5623 Lab target configuration

This document details our default lab configuration for ECEN5623. You can use this when setting up your home system to make sure that your target will behave the same as the targets in the lab. The shaded items show the configuration items which our included in the lab default Kernel. Expand your kernel configuration to match the view in the bitmap, and make sure that the same items are higlited in your configuration.

Important!!! Make sure the settings for the Etherlink match the settings you used in your config.h file when creating your boot disk!!! Values shown are the ones used in lab, may or may not match the values used in your setup. If these are set wrong, you will notice that the board will boot corectly and load the image over the network, but will not be able to be accessed by the target server.